Open the front door of the printer and remove the toner cartridge. As the separation roller, but without an access cover. Push the new roller onto this shaft until it locks in place. A), and then squeeze the locking tab on the left end of the roller and slide the roller off the shaft.

Lift the spring-loaded access cover to the left of the roller (Fig. Replace the separation roller (in the tray).The kit contains 10 feed/separation rollers, enough for five paper trays. You do not replace the pickup roller behind the feed roller, as it wears out more slowly. In each tray is a separation roller and mounted above each tray is a feed roller (Figs.When re-installing the fuser, make sure to push it in until these tabs snap into place. Squeeze the blue fuser-release tabs (one on each side) and pull the fuser straight back and out of the printer. Then rotate the bin away from the printer to release the other hinge pin. Open the bin and squeeze the right hinge pin (on your left if you are behind the printer) out of its mounting hole. Simply pull the duplexer or the cover out of the printer (from the back). Remove duplexer or duplex accessory cover. Maintenance Kit Instructions: LaserJet P4014, P4015, P4515ĬONTENTS: fuser, transfer roller, transfer roller hook, and 10 feed/separation rollers.

Hp laserjet p4015n fuser kit